Can I ask if the machine/software has the ability to create a very small sleeveless jumper style garment as a single flat panel with a hole in it for one arm opening?. The garment will then be stitched together above and below the other arm opening.
I’m not 100% sure what you mean. If you have a picture, please share it here.
Why not make the hole in the neckline and leave the sides underneath the armholes open for the side seams?! So no shoulder seams and regular seams on both sides. 🙂
You would knit the front with armholes and then go over into the neckline (you need one feeder for each shoulder) and then continue with the back. That’s possible. I assume you meant something similar?
Viewing 2 posts - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.
Join our mailing list
Be the first to know about new products, sales, and special events.